160m Loaded Vertical Antenna 3d printing and end insulator are 3d

and end insulator are 3d Printed out of the same PA6 Nylon/Glass Fiber material that is used on our other antennas

This 160m antenna is made for small lots

There is an integral vent in the bottom of the enclosure

The SWR should be below 2:1 at the resonance point

Tripod in photos not included

160m Loaded Vertical Antenna 3d printing and end insulator are 3dThis 160m antenna is made for small lots, and is a coil loaded 1 4 wave vertical measuring in at ~58ft long. It uses a 4"dia loading coil halfway up the antenna length and an integral common mode current choke at the feed point. Antenna wire is 18ga Davis Polystealth insulated wire for long term durability and strength. The coil, enclosure, and end insulator are 3d Printed out of the same PA6 Nylon Glass Fiber material that is used on our other